Troubleshooting
- There is not the genital texture on the Victoria hip!
You must create the new Victoria geometry mesh object (remapped) for apply the genital
texture (See the tutorial "Remap
Daz Voctoria V3 Geometries" Step 1...to...3)
Apply the genital Mat pose
(Pose Librarie -> "!APMatV3R_Pose" -> "Viky3RMATex" - Tutorial
"V3wwg
Textures & Morphs Installation" Step 7)
Windows users: is probable that you are using an old version of UVMapper. Only the 2.5e version allows to save the UV coordinates and the materials in a correct way, please download the last UVMapper Version from Cox site (http://www.uvmapper.com/uvmapper.htm).
Mac Users: Mac
users a happy news
UV Mapper for Mac doesn't save the materials during the UVMap conversion.
There is TWO way for use Kattiva V3 on your Mac:
1-You must create the geometries object file with any windows-PC,
then you can transfer the geometries object file on your Mac. The geometries
create with a windows-PC they are perfectly compatible with Mac.
UVS file conversion requires few minutes. After the geometries file creation,
all the other tutorial steps can be perform on your Mac.
2- Use
Maconverter by MartinC
http://www.geocities.com/SiliconValley/Sector/1306/1306/psrmconv.html
Normally Maconverter it doesn't recognize uvs file but... Try to
change the "uvs" extension by "obj" extension and
Maconverter will recognize the file and you will get your new V3 object file.
A thanks to Mr. Salvador Bernadó that has suggested me this solution.
- I have saved the cr2 file but I don't find it in the poser library.
Are you sure to have saved the cr2 file with the proper extension? (.cr2).
See the tutorial "Remap
Daz Voctoria V3 Geometries" (Step 4...to...5).
If your Text Editor program doesn't allow you to save the file with the ".CR2" extension, I suggets you "Note Tab Light" program is an excellent freeware Text Editor http://www.notetab.com/download.htm
- When I open the new Victoria V3wwg cr2 file, Poser gives an error (version 4.03).
In the poser scene there is nothing the cr2 is invisible (Poser ProPak / 5).
The cr2 doesn't read the geometries correctly. You must modify two cr2 file lines with a text
editor (notepad, wordpad, etc.)
See the Tutorial "Remap
Daz Voctoria V3 Geometries" Step (Step 4...to...5).
- When I apply a genital pose... nothing happens!
What names do you have used for save the new genital morphs targets in the Victoria figure?
If you have not used the names that I have suggested you, the poses don't work!
See the tutorial "V3wwg
Textures & Morphs Installation" (Step 8)
If you have not found the solution to your problem contact me:
arduino@magiclandia.org